1 - Timers set to +2 and +4 seconds from motor burn-out.

  2 - Charges rigged and "verified" by each of the timers.

  3 - Timers verified for pull-pin operation.

  4 - Motor built and properly secured with tape and clamp.

  5 - Timer sleds properly secured.

  6 - Pack AND secure parachute system.

  7 - Launch pad properly secured with at least 100 lbs. of holding force.

  8 - Rocket placed on pad with sufficient clearance for motor burn.

  9 - Height adjusted for staking in pull-pin system at straight angle for pin pull.

10 - Igniter placed into motor and secured at the top of same.

11 - Teflon e-match lines properly taped off.

12 - Holes in deployment tubes properly taped off.

13 - Double check pull-pins for continuity.

14 - Double check security and stability of launch pad.

15 - Double check igniter continuity.

16 - Double check parachute system is pinned for security.